1997 TR-10 all updated, very good condition. A proven reliable tie inserter/extractor it has the versatility to pull or insert ties from either side of the track. Nippers to snug the ties up and easy to use joys sticks make this a preiemer spiker. This machine is ready to work and get your job done.
Additional photos available. Call for pricing and location for inspection.
Model G-21D55-53-S, Dual hosed, 21hp, rated at 10gpm and gas fueled.
HTMA flat faced couplers included
Large capacity hydraulic cooler to enhance operator comfort and extend power unit life
Fuel level gauge
Self-contained hose reel
Lockable control panel cover
Roll over protection frame
The right power unit for those jobs where you will be using hand tools on or off the track.
Rebuilt and ready to work on the job, a Canron Juniour Tamper. Great as a chase tamper in any sized job.
Price has just been reduced so call for savings now!>
2006 Sterling hi-rail (DMF) grapple; CAT C7 engine; mag/gen set;
floating axle; DMF hi-rails; air brake equipped rail trailer; Built
Rite loader with grapple; Truck has 128,000 miles with a lot of life
left in it.
Interested, email, leave a message or call us for price, additional photos and location for inspection.
Here is a strong hard working machine capable of working on any production tie inserter/extraction job. Built tough, it has been proven to be the machine for those hard production jobs.
Available now, call, leave a message or email us for prices, location and additional photos.
1997 TR-10 all updated, very good condition and ready to be put out on your job.
The TR-10, built by Fairmont is the result of Fairmont looking to put a production tie inserter/extractor out for the industry and coming up with one of the best ever.
A strong machine, it is capable of working high production tie jobs. Due to the versatility developed by Fairmont it can extract and insert ties from either side of the track so curves with close banks won’t slow it down
Additional photos available. Call, leave a message or email us for prices, photos and location for insmpection
Have available 2010 Nordco “Grabber”; pull spikes both sides of rail. An easy machine to operate, service and move. Uses two men to pull the spikes from both sides of the rail at the same time. Powered by a small diesel engine these machines get the spike pulling job done!
Additional photos available. Call or email for pricing and where to inspect.
4-wheel drive, combo clamp, graph table, light buggies.
Ready to go to work.
Model: ECTR 10070
Serial number: 35995911
Reasonably priced and ready to go to work. A proven denpendable machine and parts are readily available. Truck and drive on drive off trailer available with it as well.
2005 F550 – 4×4, crew cab, automatic, diesel, Rafna 290 railgear, 12′ flatbed with gate, – 101,300 miles. $31,000.
2003 Ford F350 – 4×4, crew Cab; Diesel motor; 8′ box; Harsco railgear; manual front; hydraulic rear. 157,711 miles