Grabber double sided spike puller

Have available 2010 Nordco “Grabber”; pull spikes both sides of rail. An easy machine to operate, service and move. Uses two men to pull the spikes from both sides of the rail at the same time. Powered by a small diesel engine these machines get the spike pulling job done!
Additional photos available. Call or email for pricing and where to inspect.

Mk-III Model: ECTR, a good working machine

4-wheel drive, combo clamp, graph table, light buggies.
Ready to go to work.
Model: ECTR 10070
Serial number: 35995911
Weight: 62,000#

Reasonably priced and ready to go to work. A proven denpendable machine and parts are readily available. Truck and drive on drive off trailer available with it as well.

Inspection Truck

2003 Ford F350 – 4×4, crew Cab; Diesel motor; 8′ box; Harsco railgear; manual front; hydraulic rear. 157,711 miles

Custom 18’ Tie & Rail Carts

40,000 lb. axles; 70,000 lb. axles; Insulated / non-insulated wheels; Solid AR400 steel floors; Front & Rear pintel hitches; Air brakes, one or both axles; With or without lights; Approximate weight, 5000 lbs.  

Switchmaster 9000 car mover

1980 SWITCHMASTER 9000   Priced to Sell!

Hercules LP gas; Double coupler; No Train Air

Drawbar pull: 20,000# equal to a 9TM Trackmobile

An Economical answer to having to move railroad cars at an industry.  In Very Good condition and ready to work.  Especially useful in small industries where an economical car mover is needed.

A railcar moving machine, it is used to push and/or pull railcars within a plant area. It is equipped with four railwheels and four road wheels which allow the machine to travel on rail or road. The Model 9000 is equipped with two fully automatic couplers, one front and one rear, for coupling to two railcars at one time or for coupling to one railcar at either end.

Stanley HP-1 Hydraulic Power Pack

Stanley HP-1 power pack, easy to move and can power up to two tools and the same time.  A good machine with 392.3 hours on meter but needs a tune-up and battery.

Good for small jobs where a small or one man crew can do the work.  Easy to tranport in the back of a pickup truck or stored in a hi-railed crew truck.  A good little unit and priced to sell.

 

Hi-railed 99 IH 2574 withHawk H-1200 Knuckleboom

1999 International Harvester 2574 Flatbed
1999 International Harvester 530E, Eaton Fuller 8 Double L,
171,244 miles and 13,867 hours on meter. 20′ x 8′ flatbed: and DMF hi-rails with Hawk H-1200 Knuckleboom Loader.
Loader capacity:
5′: 15,200 Lbs.
10′: 7,500 Lbs.
15′: 5,100 Lbs.
20′: 3,300 Lbs.

Just put on market and available now.  Priced to sell!  Additional Photos available.

A